Lab report for n butyl bromide preparation

Some anhydrous Nassau was added. Since the mechanism is of the SN2 nature, then this implies that reaction with primary alkyl halides will be favored over secondary and tertiary.

Lab Report for n-Butyl Bromide Preparation Paper

The theoretical yield for this experiment is The purpose of this wash is to prevent the formation of polybrominated butanes from addition of any more bromine to the 1-bromobutane. The product was adhered on the surface of filter paper during suction filtration.

Synthesis of Butyl Bromide (Organic Chem Lab)?

The nylon 6, 10 was formed in the interface which was milky. Page 10 of 14 C. The colorless clear film adhered on the filter paper appeared because popularization occurs causing the solution to thicken and the viscosity to increase.

Think what is in the aqueous solution. However, alcohols readily undergo SN2 because the sulfuric acid was added which protonate the hydroxyl group in the presence of the bromide ion which changes the leaving group from hydroxide to water and allows bromide ions to react with it in the same mixture.

Treatment with cold concentrated sulfuric acid ensured that any traces of leftover alcohol were removed from the system. Transfer lower alkyl halide layer in ml conical vial using pipette. After some anhydrous Nassau were added, the solution became like glue.

Experiment 2 Preparation of N-Butyl Bromide (1-Bromobutane)

Again, remove the aqueous layer on bottom and discard. Sulphuric acid is added cautiously which generates hydrobromic acidwhich turn reacts with the alcohol upon heating to make 1- Bromobutane. The 1-Bromobutane was prepared from 1-Butanol. Please also be aware that many times compounds with higher boiling points are difficult to distill and, therefore, are distilled at reduced pressure which causes the bp to be lower.

Lab report for synthesis of polystyrene Paper

In this experiment we are using the third method to prepare the 1-bromobutane. In this experimentsodium bromide and 1-Butanol are dissolved in water.

Sulfuric acid also very concentrated acid which can affect our skin.Oct 27,  · CH Exp. 9 SN2 Synthesis of Butyl Bromide Pre-Lab Lecture Video. Mar 20,  · Home» organic chemistry» Preparation of 1-bromobutane Sunday, March 20, We must understand the procedure well enough to be able to go to then lab, get set up and execute the necessary steps quickly, efficient and accurately.

g sodium bromide, NaBr mL of n-butyl alcohol (1-butanol, molecular weight= g.

Preparation of n-butyl bromide?

The formation of n-butyl bromide from 1-butanol and sodium bromide was observed under SN2 conditions. It was observed that the bromine anion, a strong nucleophile, was able to attack the protonated alcohol and displace water, which serves as a better leaving group than the hydroxide ion. Exp.

2 butyl bromide 1 Experiment 2 Preparation of N-Butyl Bromide (1-Bromobutane)Introduction: Alkyl halides are very useful intermediates in organic syntheses. The most common syntheticpreparation of alky halides is the replacement of the OH group of an alcohol by a halogen.

Experiment 23A – Synthesis of n -Butyl Bromide – Name _____ O H N a B r, H 2 S O 4 B r 1. Data Table: Fill in the appropriate spaces in the data table below.

Nucleophilic Substitution of Alkyl Halides

A SN1 Reaction: Synthesis of tert-Butyl Chloride This lab experiment proposes the synthesis of an alkyl halide by reacting the corresponding alcohol with a hydrogen halide in an easy and inexpensive SN1 reaction. 1,2 product will be properly dried. IR for tert-butanol (A) and tert-butyl chloride (B) with a.

Download
Lab report for n butyl bromide preparation
Rated 3/5 based on 27 review